So many years ago I had an irrigation sprinkler installed to water the lawn. Over the years the nature of the yard has changed. For instance I put in a batting cage and turned that zone off since there was no longer grass.
I finally learned how to make changes to the irrigation system and I took the one inch poly pipe that had been used for the grass where the batting cage is and I ran it so it could water some of my wife’s plants. I installed 6 tees to connect 1/2 inch switch pipe which allow me to install 6 sprinklers to water the flowers. However when I tested it last night with the 1/2 inch switch pIpe which will be attached to the sprinklers there seemed to be insufficient water for the last 2-3 connections.
Thoughts?? Should I just install 3 sprinklers? Is there something else that can be done? There are other zones I have in which there are 6 sprinklers attached with no issue but perhaps there is more than one pipe run to get the water to those 6 sprinklers?
tia
I finally learned how to make changes to the irrigation system and I took the one inch poly pipe that had been used for the grass where the batting cage is and I ran it so it could water some of my wife’s plants. I installed 6 tees to connect 1/2 inch switch pipe which allow me to install 6 sprinklers to water the flowers. However when I tested it last night with the 1/2 inch switch pIpe which will be attached to the sprinklers there seemed to be insufficient water for the last 2-3 connections.
Thoughts?? Should I just install 3 sprinklers? Is there something else that can be done? There are other zones I have in which there are 6 sprinklers attached with no issue but perhaps there is more than one pipe run to get the water to those 6 sprinklers?
tia